Griffith Owner Simon Vidler has produced some Aluminium Bezels to finish of around the Push Buttons and the L.E.D's  on The Griffith Dashboard.  They can be used over the factory produced black buttons and the after market Leven aluminium  buttons.

Bezel, Black Buttons

I have recently added them to my Griffith and can say they are a quality product which really finishes of the dashboard. I had re covered my dash myself with carbon fibre and had to file the wholes out slightly with a nail file to get them in but if you have a standard one or even an after market one there shouldnt be any problem fitting them. 

Bezels Button, LED	The Bezels	Without Bezels
Without Bezels	Bezels in situ	In Situ

To hold them in place a small amount of silicon sealant is appied at the rear of the bezel and then they are pushed over the button and snuggling into the hole around the button. The same sequence is used for the L.E.D's. I think you'll agree that they finish the dash of very nicely and well done to Simon on producing these.

Finished

The cost for the Bezels is £25. If you would like to buy some then please contact Simon emailing him through clicking HERE  

Dave Entwistle has sent me a picture of his on a Stainless Dashboard for you to see.

Dave's Dash with Bezels